//
// Created by dell on 24-12-3.
//

#include "RS485.h"

extern uint32_t g_temperature_uint32;

void RS485_config(void) {
    rcu_periph_clock_enable(RS485_GPIO_RCU);
    rcu_periph_clock_enable(RS485_RCU);

    gpio_af_set(RS485_GPIO_PORT, GPIO_AF_1, GPIO_PIN_2 | GPIO_PIN_3);

    /* configure USART Tx&Rx as alternate function push-pull */
    gpio_mode_set(RS485_GPIO_PORT, GPIO_MODE_AF, GPIO_PUPD_PULLUP, RS485_TX_PIN | RS485_RX_PIN);
    gpio_output_options_set(RS485_GPIO_PORT, GPIO_OTYPE_PP, GPIO_OSPEED_10MHZ, RS485_TX_PIN | RS485_RX_PIN);

    /* configure RS485 EN Pin */
    gpio_mode_set(RS485_GPIO_PORT, GPIO_MODE_OUTPUT, GPIO_PUPD_NONE, RS485_EN_PIN);
    gpio_output_options_set(RS485_GPIO_PORT, GPIO_OTYPE_PP, GPIO_OSPEED_50MHZ, RS485_EN_PIN);
    gpio_bit_write(RS485_GPIO_PORT, RS485_EN_PIN, SET);

    /* USART configure */
    usart_deinit(RS485_PHY);
    usart_baudrate_set(RS485_PHY, RS485_BAUDRATE);
    usart_receive_config(RS485_PHY, USART_RECEIVE_ENABLE);
    usart_transmit_config(RS485_PHY, USART_TRANSMIT_ENABLE);

    usart_enable(RS485_PHY);

    nvic_irq_enable(USART0_IRQn, 0);
    usart_interrupt_enable(RS485_PHY, USART_INT_RBNE);
}

void process_command(char *cmd) {
    if (strncmp(cmd, "M1", 2) == 0) {
        printf("M1 -=-=- OK!\r\n");
    } else if (strncmp(cmd, "M2", 2) == 0) {
        // printf("M2 -=-=- OK!\r\n");
        printf("Temperature: %lu\r\n", g_temperature_uint32);
        // } else if (strncmp(cmd, "M3", 2) == 0) {
        //     char *param_str = cmd + 2; // Skip "M3"
        //     int param = atoi(param_str + 1); // Skip "S" and convert to integer
        //     if (param >= 0 && param <= 100) {
        //         printf("M3 with parameter %d -=-=- OK!\r\n", param);
        //     } else {
        //         printf("Invalid parameter for M3 command!\r\n");
        //     }
    } else {
        printf("Invalid Command!\r\n");
    }
}