#ifndef BOARD_CONFIG_H
#define BOARD_CONFIG_H

/* >>>>>>>>>>>>>>>>>>>>[RS485 PHY DEFINE]<<<<<<<<<<<<<<<<<<<< */

// #define RS485_MAX13487 // RS485 PHY : MAX13487 (AutoDir)
#undef  RS485_MAX13487 // RS485 PHY : SP3487 (no AutoDir)

/* >>>>>>>>>>>>>>>>>>>>[IIC TYPE DEFINE]<<<<<<<<<<<<<<<<<<<< */

// #define SOFTWARE_IIC // IIC Type : Software IIC
#undef  SOFTWARE_IIC // IIC Type : Hardware IIC

/* >>>>>>>>>>>>>>>>>>>>[DEBUG ASSERTIONS DEFINE]<<<<<<<<<<<<<<<<<<<< */

// #define DEBUG_VERBOSE // Debug Assertions Status : Debug Verbose Information
#undef  DEBUG_VERBOSE // Debug Assertions Status : No Debug Verbose Information

/* >>>>>>>>>>>>>>>>>>>>[EDDY DRIVE CURRENT DETECTION]<<<<<<<<<<<<<<<<<<<< */

// #define EDDY_DRIVE_CURRENT_DETECTION // Eddy Drive Current Detection : Enable
#undef  EDDY_DRIVE_CURRENT_DETECTION // Eddy Drive Current Detection : Disable

#define GD32E23XF4          0x10
#define GD32E23XF6          0x20
#define GD32E23XF8          0x40

/* MCU Type Detection */
extern uint8_t g_mcu_type;

/* Dynamic USART Configuration Structure */
typedef struct {
    uint32_t rcu_usart;
    uint32_t usart_periph;
    uint8_t gpio_af;
    IRQn_Type irq_type;
} usart_config_t;

extern usart_config_t g_usart_config;

/* Function to detect MCU type and configure USART */
void mcu_detect_and_config(void);

/* Function to get current MCU type */
uint8_t get_mcu_type(void);

/******************************************************************************/

#define RCU_GPIO_I2C         RCU_GPIOF
#define RCU_I2C              RCU_I2C0
#define I2C_SCL_PORT         GPIOF
#define I2C_SCL_PIN          GPIO_PIN_1
#define I2C_SDA_PORT         GPIOF
#define I2C_SDA_PIN          GPIO_PIN_0
#define I2C_GPIO_AF          GPIO_AF_1

#define I2C_DEBUG_UART       USART1

/******************************************************************************/

#define LED_PORT             GPIOA
#define LED_PIN              GPIO_PIN_7
#define LED_RCU              RCU_GPIOA

/******************************************************************************/

/* Use dynamic configuration instead of static defines */
#define RS485_GPIO_RCU       RCU_GPIOA
#define RS485_GPIO_PORT      GPIOA
#define RS485_TX_PIN         GPIO_PIN_2
#define RS485_RX_PIN         GPIO_PIN_3
#define RS485_BAUDRATE       115200U
#define RS485_EN_PIN         GPIO_PIN_1

/* Dynamic configuration - will be set by mcu_detect_and_config() */
#define RS485_RCU            (g_usart_config.rcu_usart)
#define RS485_PHY            (g_usart_config.usart_periph)
#define RS485_IRQ            (g_usart_config.irq_type)
#define RS485_GPIO_AF        (g_usart_config.gpio_af)

/******************************************************************************/

#endif //BOARD_CONFIG_H